Electric Scooter Forum for Scooter Enthusiasts, Scooter Chargers, and Scooter Mechanics.

Covers electric scooter models whether shared or for consumers.
By cyborgrd
Posts
#13956
Can you share some pics? How is the wire connection, now remove the GPS, etc. What is about the board? Must it be flashed or it works with the replaced controller? Please do a litte manual how to personalize the scooter.

By Madyicstik
Posts
#13965
ray_t wrote:
Sun Aug 11, 2019 6:13 pm
Madyicstik wrote:
Sun Aug 11, 2019 6:08 pm
ray_t wrote:
Sun Aug 11, 2019 6:06 pm


Yes, I also noticed this behaviour. Also if you accelerate too fast, you loose sync between phase advance and actual rotational speed.
do you know if theres a fix?

No. Should not occur with a controller that is dedicated to work without hall sensors.
Maybe my 500W controller is too powerful for the 250w (?) motor. But even after long distances my motor does only get warm moderately.

you mean it should quiet down if the motor is on load IF the controller is the "no hall sensor type"? ive actually tried this and it doesnt make a difference.

By ray_t
Posts
#14017
Madyicstik wrote:
Mon Aug 12, 2019 12:23 pm
ray_t wrote:
Sun Aug 11, 2019 6:13 pm
Madyicstik wrote:
Sun Aug 11, 2019 6:08 pm


do you know if theres a fix?

No. Should not occur with a controller that is dedicated to work without hall sensors.
Maybe my 500W controller is too powerful for the 250w (?) motor. But even after long distances my motor does only get warm moderately.

you mean it should quiet down if the motor is on load IF the controller is the "no hall sensor type"? ive actually tried this and it doesnt make a difference.
No, it should not make the motor more quiet, but prohibit it from loosing sync during acceleration.

By ray_t
Posts
#14018
cyborgrd wrote:
Mon Aug 12, 2019 3:56 am
Can you share some pics? How is the wire connection, now remove the GPS, etc. What is about the board? Must it be flashed or it works with the replaced controller? Please do a litte manual how to personalize the scooter.
GPS removal is depicted in the repair manual (link in this thread) and has also been discussed here.
You need a new controller and it's connection depends on it's type.

By Madyicstik
Posts
#14048
ray_t wrote:
Tue Aug 13, 2019 6:15 pm
Madyicstik wrote:
Mon Aug 12, 2019 12:23 pm
ray_t wrote:
Sun Aug 11, 2019 6:13 pm
you mean it should quiet down if the motor is on load IF the controller is the "no hall sensor type"? ive actually tried this and it doesnt make a difference.
No, it should not make the motor more quiet, but prohibit it from loosing sync during acceleration.
what are the signs that its loosing sync? im gonna have to buy one that doesnt have a hall sensor. care to link me to a good one? is it possible to have a higher wattage controller to run 2 motors or 2 motors needs 2 different controllers?


What firmware is this tested on? I would assume[…]

Bird zero tire help

Just wanted to update here following my successful[…]

Just to post an update to this thread, I fou[…]

I would use XT60 connectors for one. And two, the […]