A Forum for Scooter Enthusiasts, Scooter Chargers, and Scooter Mechanics.

Discuss the Segway Ninebot ES Kick Scooter in this Forum. Topics include the Segway-Ninebot app, hardware, street riding, and much more.
#10357
How to flash a god damn Ninebot Voi scooter please ? I buyed a new dash, flashed a new firmware and i get "0%
sent retry
sent retry
sent retry
sent retry
sent retry
canceled due to retry". Please please please !!! Thank you To view images REGISTER or LOGIN for full access.
To view images REGISTER or LOGIN for full access.


EDIT : My dashboard is not official, is that the problem ?
Last edited by Caca on Thu May 30, 2019 10:42 pm, edited 2 times in total.
#10612
akha wrote:
Sat May 04, 2019 2:27 pm
RostiMelk wrote:
Sat May 04, 2019 7:20 am
Hi!
Can I get a discord invite? All the old links seem to be expired.
https://sctrhck.ml/discord
These guys can convert a Ninebot using the original hardware
This server is shit I asked a question on this server and the admin says f*** you f*** you and I got banned after be 1 min in this server. Don't go to this server.
#10638
A while back i got a new control board for an ES2 scooter and it worked fine until i managed to burnt it out ( did something stupid). But instead of buying a new board i desoldered the STM chip from it and soldered it on the original locked board. I can now turn the scooter on and control all the lights and lock and unlock it but once i turn the motor and press the throttle or breaks every thing turns of.

Anyone seen this issue before? Not sure where to start the troubleshooting at this point.
#10643
Risitas98 wrote:
Thu May 30, 2019 3:57 pm
akha wrote:
Sat May 04, 2019 2:27 pm
RostiMelk wrote:
Sat May 04, 2019 7:20 am
Hi!
Can I get a discord invite? All the old links seem to be expired.
https://sctrhck.ml/discord
These guys can convert a Ninebot using the original hardware
This server is shit I asked a question on this server and the admin says f*** you f*** you and I got banned after be 1 min in this server. Don't go to this server.
Caca wrote:Me too i got banned for no reason, they ban very easily and fast To view images REGISTER or LOGIN for full access.

Which is completely normal you dumbasses; you should have checked the forum & wiki first instead of coming and polluting the discord channels

You completely deserved it To view images REGISTER or LOGIN for full access.
#11389
Hello everyone!

I was seeking for information about scooters and reverse engineering, just found this topic that is quite amazing with plenty of technical info.

I'm working on turning my Voi into a personal one without having to replace the controller (ESC).
There is no dashboard present, neither IoT ("gps") module.

I was able to start the controller / LED by the lower 5-pin connector, and read some of the data the controller is sending to the battery (BMS) and I'm capable of reading the battery info (%, voltage, t°C, and so on...) in a passive way (uart 115200)

I'd like to know if one of you had some details about how to engage the communication with the ESC ?
(start the engine, set the speed, ...)

(or any information about the protocol ahah!)

Thanks To view images REGISTER or LOGIN for full access.
By Jcg
Posts
#11449
Anonymous2 wrote:
Mon Feb 11, 2019 12:35 pm
RSB0 wrote:
Mon Feb 11, 2019 12:10 pm
There are 2 kind of scooters, both based on the Ninebot ES4

Old Brainless
-> Folding mechanism
-> Tracker is below the scooter, not connected to control board.
-> Apparently the scooter unlocks by somekind of bluetooth mechanism with some hidden code sent by the app still to be known.
-> Underlights

New Brain (like the one you show)
-> No Folding mechanism
-> Tracker is in front of the scooter connected to the control board.
-> The scooter unlocks like most rentals, using that control that receives unlocking .
-> No underlights

By now there are reports that just replacing the dashboard is not enough because the control board is flashed with somekind of custom firmware that keeps the scooter locked.

Reflashing the controlboard with the original (comercial) firmware probably does the job BUT there are still no know procedure online like there is allready for the xiaomi m365.

Share what you can find.
Good information you got there. I believe that you could in theory flash the original firmware via JTAG to USB. And a developer has put the original firmware on GitHub, for both the control board and dash. Hope someone can test this out and share us the result.

https://github.com/Ch4rlus/ninebot_firmware
i test ,all its ok .no need to change anything
#11685
Wooow!
Save urself 29 pages of reading (i spent the past hour doing it for you).
The SNSC1.0 (or Voi, or ES# whatever) personal conversion solution is NOT double confirmed in this thread!
Here are the 3 closest answers:
1. MAYBE this:
https://hackmd.io/@aJPspKtTS7Gd4_5OLC_z ... ?type=view

2. Or here:
https://discordapp.com/invite/6taauHH

3. Or maybe this:
To view images REGISTER or LOGIN for full access.
samches liked this
  • 1
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

Hey, mine doesnt have a black box whit a gps in it[…]

Check out this from Bird

https://cruiser.bird.co/ https://i.imgur.com/cVVJ[…]

Bird’s new Cruisers - WOW-

https://i.imgur.com/wbWzqa1.jpg This looks grea[…]

Covert a wheels bike?

If anyone is interested I have 2 ecu's (mother[…]