I read something about bypassing a fuse to fix problems with the Segway es2s. Has anyone tried that with a bird?
Electric Scooter Forum for Scooter Enthusiasts, Scooter Chargers, and Scooter Mechanics.
Yes it works. try it. You can use solder wire. no need to know how to solder.
i am reading the same stuff you are. i ordered some wire glue to use instead of solder (i have no knowledge of how to solder anything) but as far as i'm concerned, you just have to bridge over the fuse with a conductive material. i'll let you know how it goes. apparently it's an issue in all ninebot esx's, it's just super accelerated by the extra load of the external battery or when you keep pushing the scooter uphill.
James007 wrote: ↑Wed Feb 06, 2019 9:06 amYes it works. try it. You can use solder wire. no need to know how to solder.
https://forumkickscooter.fr/viewtopic.php?t=108dustydog256 wrote: ↑Fri Feb 08, 2019 5:18 pmJames007 wrote: ↑Wed Feb 06, 2019 9:06 amYes it works. try it. You can use solder wire. no need to know how to solder.
What fuse are we talking about? Im interested and can solder, I just cant locate any info on this.
Can you share a picture of how you installed the resistor? Would love to fix this on my scooter rather than buying a new boarddustydog256 wrote:I ended up putting a 33 ohm 1/4 watt resistor on the negative side of the headlight with minimal loss, 17mph headlight off 16 mph headlight on, easy and it also doesn't jeopardize you from overheating and frying your board when you solder.
m365 controller is damaged - found a bird zero con[…]
Is anyone going tomorrow? They are all M365's a[…]
FYI they have a proprietary screw with a 5-sided[…]
The kit that Nick87night mentioned is very handy, […]