Electric Scooter Forum for Scooter Enthusiasts, Scooter Chargers, and Scooter Mechanics.

User avatar
By TJSplash
Posts LikeBB LikeBB Avatar
#11444
Has anyone thought about ditching the M365 circuit board and going with a turn key ignition instead? I have no idea if this would work, but it's something that kind of struck me and I've seen a lot of handlebar throttle systems with them built in online
User avatar
By 365GUY
Posts LikeBB Avatar
#11458
That’s what I’m doing..
it should be here tomorrow..
it’s just a throttle with a key switch.

All you need is the controller, on/off switch, throttle, motor and battery.

The throttle key switch is nice because it takes care of two requirements in one cheap package.
The one I ordered was only about 15$ from amazon prime.
User avatar
By TJSplash
Posts LikeBB LikeBB Avatar
#11459
Any idea as to how to make the 1000w controller work? I followed LA's instructions, but I cant get the throttle to work right
User avatar
By TJSplash
Posts LikeBB LikeBB Avatar
#11461
I can get the wheel to spin when I'm setting the intelligence program, but I can't get the throttle or break to work
User avatar
By 365GUY
Posts LikeBB Avatar
#11462
That’s the same problem I had, after beating my head against the wall for a few hours I finally opened up the controller to find the throttle wires not connected to the board.
Back Slash Krash liked this
User avatar
By 365GUY
Posts LikeBB Avatar
#11479
No it wasn’t fixable as the board was kinda messed up where the wire should have gone. I returned it and bought a different brand. Should be here today.
User avatar
By 365GUY
Posts LikeBB Avatar
#11480
And yea the throttle I got was basically the same as that one but just black.

Hi, I'm going forward on the project. I'm followi[…]

hey Guys, I found a Voi Scooter that has a drain[…]

no because i didnt write anything down. i didnt us[…]

Oh, and it should be said that I usually just sh[…]