By DrDoc - Thu May 30, 2019 1:38 am
A Forum for Scooter Enthusiasts, Scooter Chargers, and Scooter Mechanics.
There might be some youtube videos out there that show how to use a screwdriver. Good luck. Remember: counterclockwise to loosen; clockwise to tighten.
jventura wrote: ↑Sun Jan 06, 2019 12:22 am@druinthor
My question, is if I take the splitter, in the picture you posted, the scooter becomes like a “Bird scooter”. Reason I’m asking is because before I learned to do this project, I directly plugged in a circuit board I bought into the Lyft scooter and blew it up. Let me tell you, I did not expect that because I plugged it into a Bird and it worked great but the scooter was destroyed, so I said the Lyft ones are new and great. Little did I know when it exploded on my hand and that thing hurt. So back to my question, is it just the splitter I need to work on, to avoid a explosion on the circuit board? Remove splitter and connect it back to the Bluetooth board and I’m back to stock, where it won’t explode again?
Buy a st link v2.
Hello, For two weeks I have the M365 PRO Scooter,[…]
oh, the two things on top are my on/off switches f[…]
Where is the battery located on the bird zero? Is[…]