A Forum for Scooter Enthusiasts, Scooter Chargers, and Scooter Mechanics.

Help, tips, technique, and frequently asked questions.
User avatar
By Pez
Posts Avatar
#6103
Under the rubber boot theres a large ass hex nut 22mm you need to lay the scooter on the side and tighten the nut . Hard to move at first but when you break it loose it will move . Easier when back of scooter is attached to the front . I would put body weight on the back while trying to tighten . Then there also is a spline inside with slots in it on the top where the neck is attached . Sometimes that needs addressed ..a special tool is needed for that . But the nut is the main issue . Once that’s tight put some superlube grease in that spring and area under the rubber boot
Sktrmkgvn liked this
User avatar
By Pez
Posts Avatar
#6259
Well first of all you think it’s tight but it’s not . Due to it’s a reverse thread . So you need to loosen it to make it tight ..(reverse thread on it ..go the other way with wrench

Hi! Bathroom shower remodel on a budget Fort Gr[…]

Hi 1) I find this model of bird in france https:/[…]

Pictures of your Scooters!

https://i.imgur.com/W4hxa3s.jpg

https://i.imgur.com/rZW8Ghe.gif Haven't found a[…]