An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Electric scooter lights, horns, and other general hardware topics covered here.
#21172
1. What end of the charger port do I remove to get it out of/ into the scooter:

A) The round end that just out of the scooter: detach the two wires that go into it?
OR
B) The square end that connects inside the scooter - somehow get the prongs out of it?

2. How do I do it?

There is just no way to remove the assembly out of the scooter whole - the hole on the chassis where the port comes out is too small and there is no other spot.

See pictures: note that the charger port I bought (and the one in there right now) both have the white bit attached.

_________________________________________________
BACKGROUND:
* I'm replacing the 2-port charge port that comes with the Rad2Go Scooter with a 3 port
* This is because I found it very difficult to get a 2-port charger, 24 volts (esp with up to 3.6 amps)
To view images REGISTER or LOGIN for full access.

To view images REGISTER or LOGIN for full access.

To view images REGISTER or LOGIN for full access.

To view images REGISTER or LOGIN for full access.

Is anyone willing to help me out here? I'm using a[…]

Torrent: Una foto antes de morir20183.7 Escuadr[…]

Torrent: De Piraten Van Hiernaast Bande-annonce ([…]

Torrent: Animation Watch Movie Stream Desca[…]