An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.
But what do you flash to it lol connecting doesn't do much unless you have something to send to itbluemeanie223 wrote: ↑Wed Nov 22, 2023 10:27 amConnect with cmsis dap And use arterytek isp.
Or stlink V2 and openocd
Enjoy
HI @Risitas98, I have this SNSC 2.3 ESC which if you power it the red light comes on and the green one flashes, I have tried to connect via STLINK and I have not been able to in any way, seeing your comment that there are ESCs with old designs and AT32 I'm thinking if this could be the case. Is there a way to find out with the references that I gave you in the images, or do you have to necessarily remove the damn gelatinRisitas98 wrote: ↑Thu May 16, 2024 8:01 pmI have an older design 2.3 controller but with an at32 chip. So the pcb layout is the same as older flashable ones wit stm32, the only visible difference is the at32 chip. I managed to flash a retail at32 firmware with rollerplausch downgrade software but it doesn't work (it shutdown instantly when I'm not pressing the button). It manages to react with bluetooth, I can flash firmwares on it but it cannot be used...The only solution is to install shfw but it's made to brick 2.3 controllers...
- By PurpleO
Below is the link with some information about ca[…]
- By sunny
@pawel1201 great work, Two questions 1. How can […]
- By iddik75014
looks good. on - minus tab of battery, solder th[…]
- By Jevako030
no, you have to replace the original controller
