[Leon Kolaric]

Hi, im wondering if anyone here has spare display for lime gen 3..Mine is cracked

[gtramt1]

Hi, im wondering if anyone here has spare display for lime gen 3..Mine is cracked

I have to check... probably I didn't throw it away...

[onlyindadescooters]

i do

[A-Emilee]

I have sccessfully reverse-engineered the communication of the blackbox and created a replacement with custom app using an esp32. I have documented it all on github: https://github.com/A-Emile/Lime_Gen3_IoT_Replacement

[STM32F103:)]

A-Emilee: you have killed the game!

[PDruppo]

I hacked gen 3 with chinesse controller (with hall sensors but not connected) its loud at start anyone know how to repair that ?

Hey, can you write to me PV, so we can talk?

[alecxs]

Is there a chance to get this scooter unlock without flashing unlocked firmware? I don't wanna open the controller. is it that what unlock? or is that flashing unlock of stm32 only..
viewtopic.php?p=53418#p53418

and can anyone explain that magnetic thing, does it mean we can get free ride without removing screws just with magnet?
viewtopic.php?p=18776#p18776

[alecxs]

hello I'm trying to communicate with a st-link v2 but impossible he shows me a message

No need for reset pin 7 or something, just disconnect every power source (battery, charger) only provide power 3V3 from ST-Link v2.

The SWD serial port is disabled in firmware, but it is enabled in bootloader.

Choose the 'connect under reset' option. then plug in the ST-Link to usb port + immediately click 'connect'. It will work, it is just a matter of correct timing. Try a few times until you catch the bootloader.

Once it is connected, you will see another error message 'readout protection'. You can now erase the STM32 by disabling the readout protection in 'option bytes' in ST-Link Utility.

Good Luck!

[alecxs]

I made a PCB for the green box. it is pin compatible with most esp32, you just have to add compatible dc-dc converter. if you don't have a heat gun you should order PCB with connector assembled on the bottom side, for 2 bucks more (BOM inside zip). it's the first revision, please report here if you find bugs.

[insestito]

I made a PCB for the green box. it is pin compatible with most esp32, you just have to add compatible dc-dc converter. if you don't have a heat gun you should order PCB with connector assembled on the bottom side, for 2 bucks more (BOM inside zip). it's the first revision, please report here if you find bugs.

I just ordered the PCB, THANK YOU ENOUGH mate!
What DC converter do you recommend and what other things do I need?