gtramt1 wrote: ↑
Tue Jun 21, 2022 1:22 am
Mrkris7100 wrote: ↑
Mon Jun 20, 2022 7:05 pm
tone_loc88 wrote: ↑
Sat Jun 11, 2022 3:00 am
I'm having a serious problem using st link v2. I think I pressed some things I shouldn't have and can now no longer connect my shitty st link v2 clone. it says things like cannot connect to target. I've tried on 3 diff ones too. any idea what I can do to get this thing to connect to my computer? I heard you to reset you connect connect rst pin and ground than click connect and when pressing it disconnect the wire. but nothing seems to happen. I'm Soo frustrated
I have same issue. I connected controller using 4pins on PCB to STLINKv2 on my STM32 Discovery board. And software says cannot connect to target. As i read there is LED on the board which should turn on or blink? Mine is not lighting up when i connect programmer. Are other parts of scooter required? Battery or green box?
hi, as far as i remember (it was done 2 years ago i think) i had to connect everything (green box, motor, battery, controller) for successful flashing...
really? connect everything? that can't be right. I'm starting to think my shitty clone boards are just bunk. I guess I'll buy another one. any recommendations on a diff type of board I could buy to flash this sh*t? besides those shitty st link clones. I have a USB to ttl uart board but I have no idea how to hook up the pinnout to these since it's "rx, tx, etc" connecting to "dio, clk, etc""