By Mrkris7100 - Mon Jun 20, 2022 7:05 pm
- Mon Jun 20, 2022 7:05 pm
#56897
I have same issue. I connected controller using 4pins on PCB to STLINKv2 on my STM32 Discovery board. And software says cannot connect to target. As i read there is LED on the board which should turn on or blink? Mine is not lighting up when i connect programmer. Are other parts of scooter required? Battery or green box?tone_loc88 wrote: ↑Sat Jun 11, 2022 3:00 amI'm having a serious problem using st link v2. I think I pressed some things I shouldn't have and can now no longer connect my shitty st link v2 clone. it says things like cannot connect to target. I've tried on 3 diff ones too. any idea what I can do to get this thing to connect to my computer? I heard you to reset you connect connect rst pin and ground than click connect and when pressing it disconnect the wire. but nothing seems to happen. I'm Soo frustrated