An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Electric scooter lights, horns, and other general hardware topics covered here.
#21172
1. What end of the charger port do I remove to get it out of/ into the scooter:

A) The round end that just out of the scooter: detach the two wires that go into it?
OR
B) The square end that connects inside the scooter - somehow get the prongs out of it?

2. How do I do it?

There is just no way to remove the assembly out of the scooter whole - the hole on the chassis where the port comes out is too small and there is no other spot.

See pictures: note that the charger port I bought (and the one in there right now) both have the white bit attached.

_________________________________________________
BACKGROUND:
* I'm replacing the 2-port charge port that comes with the Rad2Go Scooter with a 3 port
* This is because I found it very difficult to get a 2-port charger, 24 volts (esp with up to 3.6 amps)
Image
Image
Image
Image

As this was a rental version whos overstock was […]

Any one got any info on beryl bikes I seen a few[…]

LH/ TF-100 Style Display.

Hi I recently converted a Bird Zero to a personal […]

How do you operate dash without button? I have[…]