[kokotito06]

My dashboard has the pins cutted off where you would connect to the st-link , is there any way to flash it or I need to buy a new dash

[tomes]

not sure how to answer your question, sorry - but i’m working on an es1, and i would like to ask, how did you get the dashboard out? i opened the scooter, and tried unscrewing everything, but i can’t figure out how to remove it. also, is the gps located in there? thanks

[Jsjjdbd]

you would need to buy a new OEM one but what scooter company did you get the dash off from

[karlitos289]

not sure how to answer your question, sorry - but i’m working on an es1, and i would like to ask, how did you get the dashboard out? i opened the scooter, and tried unscrewing everything, but i can’t figure out how to remove it. also, is the gps located in there? thanks

quita lo 4 pernos que sujeta el timón, luego por dentro tiene 2 tornillos que debes retirar, retira la tapa de plástico y empuja hacia fuera el faro led, luego veras otros dos tornillos, los quitas y retiras la tapa de plástico luego empuja el tablero hacia arriba, depende de que empresa sea se sabrá si tiene o no gps.

Si quieres retirar la placa principal tendrás que quitar la batería que esta dentro del tubo.

[karlitos289]

My dashboard has the pins cutted off where you would connect to the st-link , is there any way to flash it or I need to buy a new dash

No veo que este cortado, creo que aun puedes flashearlo, solo suelda los pines donde corresponde.