- Fri Dec 13, 2019 6:23 am
#18110
Has anyone managed to completely convert a Voi into a personal scooter?
An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.
Do you have a link to buy the arduino nano and where do we put it. Do you have some photo of the process ?Marius Petz wrote: ↑Sat Dec 07, 2019 1:33 pmHey guys,
there is a solution for the VOI ES-100D Scooter. The Source Code is written by MrSpriggs1.
I want to give you an instruction.
What you needThats it!
- Arduino Nano
Upload following Code to the Arduino Board:Code: Select all!!!Written by MrSpriggs1!!!#include <Arduino.h> int powerPin = 5; byte messageA[] = {0xA6, 0x12, 0x02, 0x10, 0x14, 0xCF}; byte messageB[] = {0xA6, 0x12, 0x02, 0x11, 0x14, 0x0B}; byte messageC[] = {0xA6, 0x12, 0x02, 0x15, 0x14, 0x30}; void setup() { // initialize Serial: Serial.begin(9600); pinMode(powerPin, OUTPUT); digitalWrite(powerPin, HIGH); } void loop() { delay(500); Serial.write(messageC, sizeof(messageC)); }
Now connect the yellow wire to the RX, the green wire to the TX and the blue wire to the 3V3 Pin.
Don't connect the red wire to the arduino or you will blew up the board of the arduino.
Now power up the arduino and wait some seconds. After a small delay your scooter should turn on.
You don't have to buy new controllers or something.
yup es2 ninebot. changed the controller and circuit boardrebellion2 wrote: ↑Fri Dec 13, 2019 6:23 amHas anyone managed to completely convert a Voi into a personal scooter?
No they's no gps in the big , removable battery yo[…]
As this was a rental version whos overstock was […]
Any one got any info on beryl bikes I seen a few[…]