An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Discuss the Xiaomi mijia mi M365 original and pro versions in this forum. Topics include hardware, software, hacking, riding, and everything in between.
By Whereismaddi
#15448
Is there a guide anywhere on how to replace the rear wheel with a front wheel?

Thanks guys
User avatar
By hudgat
#15453
Top corner of the webpage has a search feature, we have a thread on this every other week pretty much
User avatar
By Back Slash Krash
#15455
I found that the rear was a little on the flimsy side so i took a set of front forks with a motor in them and i bolted them into the rear forks on the m365.
Image
User avatar
By hudgat
#15465
Back Slash Krash wrote:
Thu Sep 12, 2019 5:11 pm
I found that the rear was a little on the flimsy side so i took a set of front forks with a motor in them and i bolted them into the rear forks on the m365.
Image
woah nice is that m365 fork with a zero motor?
By Whereismaddi
#15475
Should I connect my 2 controllers to one battery each or connect my 2 batterys together and both controllers to that.

Also how do I flash my new controllers firmware do I disconnect bluetooth module from first controller , and connect it to the new one and then flash it and then disconnect it and reconnect it to the original one.
User avatar
By Back Slash Krash
#17931
I actually connected 2 totally seperate batteries to individual controllers and ran them to two dashes that were side-by-side and connect to the same handle bar then I actually ran them to two separate throttles on the right side and I put brake levers on both right and left side and I eliminated the brake line and just connected the brake wires so that both front and rear brakes where braking . For the rear wheel I used a bird zero motor for the front wheel are used some thing that came off of a local proprietary scooter from San Diego called her go ask motor but it was basically just an M3 65 motor or at least it looked like one
User avatar
By Back Slash Krash
#17932
hudgat wrote:
Thu Sep 12, 2019 10:08 pm
Back Slash Krash wrote:
Thu Sep 12, 2019 5:11 pm
I found that the rear was a little on the flimsy side so i took a set of front forks with a motor in them and i bolted them into the rear forks on the m365.
Image
woah nice is that m365 fork with a zero motor?
Actually its the front forks from a Lime S 2.0. And yes the motor was from a zero. When you hook up the wires to the m365 controller from the zero. You gotta swap the green and blue phase wires as they connect to the controller . Yellow stays the same place
By m365b
#18030
Very creative to use an existing front fork for the rear motor install. For the bird motor, there have been cases where it burns out the mosfets on the controller. Not sure if this is due to the motor power constant set too low when changing the firmware or if it has to do with the regenerative braking + bird motor. How long have you been riding your dual motor scooter and did you change your motor power constant?

As this was a rental version whos overstock was […]

Any one got any info on beryl bikes I seen a few[…]

LH/ TF-100 Style Display.

Hi I recently converted a Bird Zero to a personal […]

How do you operate dash without button? I have[…]