By tokala - Fri Oct 04, 2019 4:34 am
So I recently purchased 4 of these scooters from University of California Riversides Excess Equipment sale for $30 each. (I guess they are illegal on campus and beat Lime in court.)
Anyways, luckily this post has been restored for me to gather some information on this communication protocol. I will not post code, but SUDO code.
I am assuming from your post that we are communicating over serial at 9600 baud. Is this correct?
If I just wanted to say turn on the headlight and do nothing else would the following work?
Start serial connection
Apply voltage to Blue Wire
Send Light On Command {0x46 ... 0x26}
I did these things but didn't get the scooter to do anything. Not even turn the screen on. I know that the screen works as when I charge the unit it shows the battery percentage and shows an error code.