I need your help to confirm my connections please! I connected all wires after reading everything in this topic.
I connected the Throttle, Motor & Hall Sensor wires and the Battery. I followed the colors of the wires, just left unconnected one white wire (that comes from the Motor\Hall sensor cable):
=>
I connect the two Red wires from the controller (one thick and other thin ) to the Battery positive and the Thick Black wire to Negative, i use one XT-60 connector:
=>
Then, i connect the 3 Phase wires from controller to the motor and 5 Wires to Hall Sensor cable (macthing the colors):
=>
I connect the Two White wires (self-learning):
I reviewed all the connections, and try to plug for the first time the XT60, but when I was connecting it made a
spark. It is normal? And I did not try again..
So, i only made this connections:
Did i connect something wrong? The spark should not happen? The Battery is full of charge (41V).
Should i try test only the controller and the throttle (without connecting the motor) and with the Charger (42V) instead the Battery?