An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.
solarwasser wrote: ↑Fri Mar 20, 2020 4:12 pmHey guys can you check my wiring.
I left the blue and the red cable between IOT and ESC connected. I put both ends of the black in Arduino GND.
Is it correct? I know SEBI connected the blue cable to a 3.3V is it nescessary? Or can I leave it connected between IOT and ESC?
1215941571 wrote: ↑Sat Mar 21, 2020 2:53 amDo you think its possible that the scooter will send the same security codes each boot/each time its enabled? I am theorizing that this may be true if the codes are based off of the internal time clock + serial #. If it does, I was wondering if we could capture the codes for like the first hour or so and just store them on the microcontroller to send, and reboot if the scooter is on for longer then that. Not sure if this is a solution that could work though.
fogfog wrote: ↑Tue Mar 24, 2020 6:46 amHi all,
I'm not an expert, but would it be possible to bypass the read protection from the STM32 using this method?:
https://www.aisec.fraunhofer.de/en/Firm ... ction.html
Hello everyone, I have a Ninebot G30 Max that sud[…]
it do! just controller, lcd and the origin[…]
modification of the chinese controller to connect […]
3000w I use the bird one motor (590) with black […]