An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Changing mobility one trip at a time.
By Scootermansussex
#57526
Wish me luck I going to try feeding a small fibre glass rod dow the side of the BMS and cutt round the edge with dental floss an the hopefully slide pack out
By Scootermansussex
#57555
Elo mate I just disconnected the BMS negative out and put the wire on the negative battery terminal next to it all charges go through BMS so all good and I keep a eye on battery voltage make sure it don't drop below 42v . I will fit a BMS but was eager to test it
Image
Image
By Scootermansussex
#57556
If u didn't want to fit a BMS u could just nip the corner of pack off and swap wires round and would look a lot cleaner also could be re waterproofed with silicone

As this was a rental version whos overstock was […]

Any one got any info on beryl bikes I seen a few[…]

LH/ TF-100 Style Display.

Hi I recently converted a Bird Zero to a personal […]

How do you operate dash without button? I have[…]