An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Changing mobility one trip at a time.
#52829
MrSpriggs1 wrote:
Fri Dec 06, 2019 10:37 pm
Well, I see my mistake Im working with an Adafruit feather M0 not a Nano. You might want to remove the one from Serial1. Here is a correction below. Im not going to make any promises but hopefully it might help. You might have to get a logic analyzer and hook up to the GPS
electricool wrote:
Fri Dec 06, 2019 7:34 pm
MrSpriggs1 wrote:
Fri Dec 06, 2019 5:29 pm
So after a bunch of time painting my new pretty scooter.
I found out you only need these 5 hex numbers to make it light up and go. Now how do you go fast?
Code: Select all
#include <Arduino.h>

int powerPin = 5;
byte messageA[] = {0xA6, 0x12, 0x02, 0x10, 0x14, 0xCF};
byte messageB[] = {0xA6, 0x12, 0x02, 0x11, 0x14, 0x0B};
byte messageC[] = {0xA6, 0x12, 0x02, 0x15, 0x14, 0x30};

void setup() {
  // initialize Serial:
  Serial.begin(9600);

  pinMode(powerPin, OUTPUT);
  digitalWrite(powerPin, HIGH);

}

void loop() {
  delay(500);
  Serial.write(messageC, sizeof(messageC));
}
hello and thank you for sharing the result of your work, I wanted to know on which ESC you used this code, I have a ESC100 of the company bird but it does not work on

thank you and good luck
heloo this code work for bird zero 2 min and scooter off please help

  • 1
  • 70
  • 71
  • 72
  • 73
  • 74

Where do u live ?

On weekend my goal is to disassemble the whol[…]

NineBot Max - Attempt

very well done! a+!! https://i.imgur.com/TLiN[…]

Hi, I use my m365 with only one external battery, […]