- Tue Feb 14, 2023 10:04 am
#57604
Is it always necessary to remove the C2 capacitor, if present, from any/every dash circuit board before flashing with ST-Link? (To make the board flushable with an ST-Link v2 device?)
Anyone with any knowledge or experience with flashing any dashboard is invited & encouraged to respond!
I suspect (and expect) that this information would be of great interest & value to almost anyone who visits/uses this forum. And having this critical detail resolved here, in its own easy to find thread, will be very helpful.
If this is query has actually already been directly & unambiguously addressed on this forum, I would argue that it was not expressed clearly, concisely or specifically; OR it is not posted in a thread with a title/subject that mentions ST-Link, flashing, or dashboards
Thank you so much!
Anyone with any knowledge or experience with flashing any dashboard is invited & encouraged to respond!
I suspect (and expect) that this information would be of great interest & value to almost anyone who visits/uses this forum. And having this critical detail resolved here, in its own easy to find thread, will be very helpful.
If this is query has actually already been directly & unambiguously addressed on this forum, I would argue that it was not expressed clearly, concisely or specifically; OR it is not posted in a thread with a title/subject that mentions ST-Link, flashing, or dashboards
Thank you so much!