An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Micro mobility projects built using electric scooter components.
By Spinnanz
#52579
I bought a kids kick scooter, with plans to convert it to electric.

The hub motor is rated at 36v 250w, which I have previously tested on another scooter. When on the other scooter, I ran it on 36v.

Plans for this scooter are to run it on 48v, at 13a. This should make it 620w. The battery has a mount, which will be mounted on the handle bar stem. Initially I'll use a cheapo china controller that's rated at 350w but I know run 620w no problem.

If it all goes well, I've ordered a spot welder so will go the full send and make a 72v battery up. It might go boom, it might not, we will see.

The silver scoot was my test scoot, so check the motor and controller were all good.

Drill hole and solder jumper ? Do you mean solde[…]

Hi All, Just wondering If ya all got any teardown,[…]

SNSC 2.4

Alright mate could you be abill to do that bypass […]

I got the battery out of the casings, and I didn't[…]