An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Covers electric scooter models whether shared or for consumers.
By ashkaty
#55627
Hey! I recently bought a Lime 2.5 off eBay and have been working on converting it. I used a brainpower motor controller that came with an lcd display. I successfully got the wheel to run on its own using a motor override function built into the lcd display, but I can’t get the motor to run using the throttle. I was wondering how you’re supposed to hook up the throttle and brakes of the lime to the motor controller normally, so I can figure out if I soldered the wires wrong. Attached is the wire set up of the controller I have.

Let me know if more info is needed, thanks!
Image
By ashkaty
#55648
I did, but that post says the accelerator and brake pins are a 1:1 connection to the new motor controller which I don't think they're not. At least I didn't see any 1:1 connections. I had to solder the wires on. Thanks for the advice though!
LIME 3.GEN PERSONAL.....

Hi alecxs, the main Version from Emile ist runni[…]

No they's no gps in the big , removable battery yo[…]

As this was a rental version whos overstock was […]

Any one got any info on beryl bikes I seen a few[…]