- Thu May 11, 2023 7:25 pm
#57777
Hi everyone.
I bought a used 1s scooter that had the small cables comming from the motor ripped, when testing if the cables were the only issue I did a quick soldering of the orginal broken cables to see if when they are connected the scooter works and it worked (of course I had the cables disconnected from the board when putting them together). So I aquired brand new motor cables, removed the orginal cable, leaving about 3cm of cable lenght by the motor so I can solder the new cable to the old wires, after putting everything together I am getting “error 18”, I checked all coonnections are holding up great and are not exposed.
What could be the issue here?
I bought a used 1s scooter that had the small cables comming from the motor ripped, when testing if the cables were the only issue I did a quick soldering of the orginal broken cables to see if when they are connected the scooter works and it worked (of course I had the cables disconnected from the board when putting them together). So I aquired brand new motor cables, removed the orginal cable, leaving about 3cm of cable lenght by the motor so I can solder the new cable to the old wires, after putting everything together I am getting “error 18”, I checked all coonnections are holding up great and are not exposed.
What could be the issue here?
- By Cyberboy55126
- By alecxs