Page 1 of 1

Flashing LIME Dashboard QWC DZ16V3

Posted: Fri Jan 10, 2020 8:09 am
by Batou
Hello, I have bought at Facebook Market the LIME Dashboard QWC DZ16V3
And I have a question - it's possible to flash it by ST LINK V2 This way:
https://www.scooterhacking.org/forum/viewtopic.php?t=15

Pinouts seems good, but if I put 5V VCC, dash not starting - maybe it need "start byte" from controller?
Controller not start, becouse haven't command from security dash :)
It's possible to start dashboard only and flash them by ST-LINK V2?

The QWC DZ16V3:
Image

There are Security dash:
Image

And controller board pinouts:
Image

Re: Flashing LIME Dashboard QWC DZ16V3

Posted: Thu Feb 13, 2020 6:48 am
by moritzbruno@msn.com
Hello have you found a solution because I am in the same case as you thank you

Re: Flashing LIME Dashboard QWC DZ16V3

Posted: Thu Feb 13, 2020 10:13 am
by Scootingxiv14
From the pic you posted the writing of the letters you'll need a usb uart serial cable like this .St link is a whole different program.which lime generation are you workn on .
Image wish I could help out more but never worked on lime .

Re: Flashing LIME Dashboard QWC DZ16V3

Posted: Fri Feb 21, 2020 4:09 pm
by Bee-Rad
Those are the same dashboards in the Lime SJ2.5 and I believe may be the same as the F350 Jump and Bird Zero.

Either way this one is powered by 36V from the battery, not 5V via a stepdown like most others which might be why it’s not powering on.