- Wed Dec 14, 2022 11:43 am
#57465
I everybody,
I am a French Guy and there is no forum on g30..
So, I search a lot of information and take on this forum but I have already a problem ...
I try to put an 12V bat in serie on my g30.
No problems to mount.
Then I test, and after maybe 15s the scooter shut off...
I take off the 12v batt and then with stock batt I have er 21 no data in bms...
I test 12v batt, she is dead and voltage go 10,5 to 12 Permanently.
But, for my original batt, tension is good...
I try a reset off her, nothing change
I try with level 3, no err but the scooter switch off after 50m....
I try to manage with a St link, I can read the board, then put 134 hex dump file. Control with the program is ok...
The blue led still blinking, and red if I put charger then blue.
However I still have no bms data, no battery level on dash....
Do you think battery is dead? Or maybe only bms?
Sorry for my American, complicated to write without mistake
Thanks to all
I am a French Guy and there is no forum on g30..
So, I search a lot of information and take on this forum but I have already a problem ...
I try to put an 12V bat in serie on my g30.
No problems to mount.
Then I test, and after maybe 15s the scooter shut off...
I take off the 12v batt and then with stock batt I have er 21 no data in bms...
I test 12v batt, she is dead and voltage go 10,5 to 12 Permanently.
But, for my original batt, tension is good...
I try a reset off her, nothing change
I try with level 3, no err but the scooter switch off after 50m....
I try to manage with a St link, I can read the board, then put 134 hex dump file. Control with the program is ok...
The blue led still blinking, and red if I put charger then blue.
However I still have no bms data, no battery level on dash....
Do you think battery is dead? Or maybe only bms?
Sorry for my American, complicated to write without mistake
Thanks to all