Electric Scooter Forum for Scooter Enthusiasts, Scooter Chargers, and Scooter Mechanics.
Ok I believe G and B are need to be switched and Y always stays with Y. Can't be 100 % sure. I never tried the es4/zero swap but did do m365/es4 and m365/zero swaps. I wouldn't worry about anything exploding really.... What I'd do is cut old connectors from zero wheel and use ones form stock ES4. Most wiring will match leaving one or two wires to mix and match. Just make sure to keep the battery disconnected when trying different configurations and plug it in only when trying the setup...Coolcalmgabe wrote:I'm trying to rewire a B-0 tire run on an es4 but im not having any success. Do I just have to try all 36 possible connections (G,B,Y)? What is the safest way to do that without any to limit the voltage so it doesnt explode? And what about the amplifiers on the B-0 tire that are connected to the white wire? What do I connect them to if the batter doesn't have the sixth pin?
In a nutshell.... So I'm thinking of offering t[…]
Have you guys tried to flash the firmware again m[…]
Thx for the link. The app didnt flash the firmware[…]
Plug a charger in and manually flash it. Since you[…]