An Electric Scooter Community on a Mission to Stamp out Transportation Mediocrity.

Discuss the Segway Ninebot ES and Ninebot Max Kick Scooter in this Forum. Topics include the Segway-Ninebot app, hardware, street riding, etc.
By cyberguy
#56239
[quote=Baydndnd post_id=18148 time=1576361978 user_id=18391]
[quote="Marius Petz" post_id=17953 time=1575743601 user_id=18284]
Hey guys,

there is a solution for the VOI ES-100D Scooter. [b]The Source Code is written by MrSpriggs1[/b].
I want to give you an instruction.

[b][u]What you need[/u][/b]
[list]Arduino Nano[/list]

Thats it!

Upload following Code to the Arduino Board:
[code]#include <Arduino.h>

int powerPin = 5;
byte messageA[] = {0xA6, 0x12, 0x02, 0x10, 0x14, 0xCF};
byte messageB[] = {0xA6, 0x12, 0x02, 0x11, 0x14, 0x0B};
byte messageC[] = {0xA6, 0x12, 0x02, 0x15, 0x14, 0x30};

void setup() {
// initialize Serial:
Serial.begin(9600);

pinMode(powerPin, OUTPUT);
digitalWrite(powerPin, HIGH);

}

void loop() {
delay(500);
Serial.write(messageC, sizeof(messageC));
}[/code]

[b]!!!Written by MrSpriggs1!!![/b]

Now connect the yellow wire to the RX, the green wire to the TX and the blue wire to the 3V3 Pin.

Don't connect the red wire to the arduino or you will blew up the board of the arduino.

Now power up the arduino and wait some seconds. After a small delay your scooter should turn on.

[b]You don't have to buy new controllers or something.[/b]
[/quote]

Do you have a link to buy the arduino nano and where do we put it. Do you have some photo of the process ?

Thank you very much.
[/quote]


When I measure pins yellow and green shows 3.3 v blue and red is showing 36 v on multimeter, if I solder blue wire on arduino 3.3 pin I will burn it I assume. Any suggestions
By fafoul69
#56700
Risitas98 wrote:
Fri Jan 31, 2020 4:23 pm
careragt35 wrote:
Sat Jan 11, 2020 5:24 am
I found Voi scooter
it looks like a modified version of the ninebot max g30d


Image

Image
Image
Image
Image


is this the same as the ninebot max g30 ?
Dear parisian baguette thief, this model is not hackable. Too hard and not beneficial for your business because the hardware is protected. You should left it on the street and call voi to repair the scooter.
do you have this scooter?
  • 1
  • 40
  • 41
  • 42
  • 43
  • 44

DO NOT BY PASS BMS i removed the old BMS and inst[…]

LIME 3.GEN PERSONAL.....

Hi, im wondering if anyone here has spare displa[…]

PaulNathan, je suis français aussi, ouvre t[…]

Hi.I just cannot manage to read,identify the stm32[…]