By FrogmanMJ - Sat Aug 21, 2021 6:32 am
- Sat Aug 21, 2021 6:32 am
#54524
Hi mayaku
How did you figure it out? I still can not connect and have the same message.
Thanks
mayaku wrote: ↑Mon Sep 28, 2020 2:07 pmUnfortunately my ST-Link V2 gives me an error when I try to flash the motorcontroller:
20:00:04 : Can not connect to target!
Please select "Connect Under Reset" mode from Target->Settings menu and try again.
If you're trying to connect to a low frequency application , please select a lower SWD Frequency mode from Target->Settings menu.
20:00:05 : No target connected
I tried everything but with no success.
But i can confirm that the magnet switch is present in the german version, too ^^
EDIT:
My ST-Link V2 works and I updated everything, but I guess I found the problem:
It's a CMOS Operational Amplifier which is broken for sure.
When I connect the motorcontroller to both, battery and charger the red LED starts flashing 7 times.
Hi mayaku
How did you figure it out? I still can not connect and have the same message.
Thanks