- Thu Oct 13, 2022 2:49 pm
#57212
Hello,
I just wanted to modify my good old reliable Gen3 with a VESC, so far the setup proccess caused a lot of headache, but now its running, kind of.
Im using a Flipsky75100 and it feels like it doesnt squeeze that much juice from it as it could.
Im still waiting for the bt module, so I can do some more identification, but was curios if someone can share theyr settings, to verify im not totally wrong.
Battery Limit: 75A
Regen Limit: 30A
Phase current: 60A (as I think higher does overheat the esc)
Magnet count: 30 (is it right that the motor also uses 30 magnets)
Pls share your stuff
I just wanted to modify my good old reliable Gen3 with a VESC, so far the setup proccess caused a lot of headache, but now its running, kind of.
Im using a Flipsky75100 and it feels like it doesnt squeeze that much juice from it as it could.
Im still waiting for the bt module, so I can do some more identification, but was curios if someone can share theyr settings, to verify im not totally wrong.
Battery Limit: 75A
Regen Limit: 30A
Phase current: 60A (as I think higher does overheat the esc)
Magnet count: 30 (is it right that the motor also uses 30 magnets)
Pls share your stuff
- By Cyberboy55126
- By alecxs