[TheElevator]

I measured the pinout for the battery pack and the battery tray.


On the left you can see the "Power Out Connector".
On the right you can see the "Charge Input".
The bottom of the battery can be seen in the middle.


Here is the battery tray:


This is how i bridged "P1+" and "P2+", so that the battery thinks it's in the tray.:


Charge Port Input:


Powerconnector Output:

[baubabauu]

Did u try the battery after bridged those 2 pins în order to see if doesn't run into protection?

[TheElevator]

Did u try the battery after bridged those 2 pins în order to see if doesn't run into protection?

At the moment I cannot test whether it goes into protect mode, because I don't have anything with that kind of energy requirement.
My M365 only runs in emergency mode up to 12kmh and with DPC up to 42kmh, but little acceleration...

But i will test it as soon as possible

[iddik75014]

How does the battery lock open on this model? I will not find information about this model.
https://www.theverge.com/2020/11/19/215 ... it-quarter
I can't insert a photo(((
also Lime gen4 but not the same as yours.

p-s- problem solved. just pry off with a screwdriver.

Hello,
Please how did you extract the battery for the Lime modele : https://www.theverge.com/2020/11/19/215 ... it-quarter
?

I have saw there is a charger connector under the battery on the frame... so no need to extract the battery ?

Is the controler located in the back ? I mean close to the rear wheel ?

[TheElevator]

Did u try the battery after bridged those 2 pins în order to see if doesn't run into protection?

sadly that doesn't fix the protection ... you have to cut open the battery case And bypass the BMS.

[iddik75014]

Bought this 1000w controller

Made the settings to display exactly as other kind of scooter that has 350w controller. That scooter goes 28.5 km/h if it is on table suspended , and this one has top speed 82.8 km/h.
The only problem i have is that the battery goes into prottection after a few seconds . I have to bypass the bms. Any suggestion about that?

Hello,
Does that 1000w controler works with the Lime-s 4.0 ?
As far as I know the Lime-s 4.0 is a 250 w motor power with 37 V DC.

Battery capacity 12.4 ah and 458.8 wh.

Please let me know where to pry off to take out the battery.

[iddik75014]

I mean that battery model on Lime-S 4.0 :
I couldn't take it off.

Please help

[baubabauu]

Did u try the battery after bridged those 2 pins în order to see if doesn't run into protection?

sadly that doesn't fix the protection ... you have to cut open the battery case And bypass the BMS.

Managed to push ouț the batteries for case and bypass the bms. It works.

[feaoafhzap]

@baubabauu Can you give more details on what you did ?
Did you cut the aluminium case of the battery to access to BMS (if yes, how did you do to make it properly?)

I don't understand your drawing. You cut the charging wire from the BMS ?
Thank you

[iddik75014]

I don't understand your schema.

Could you explain how to extract the battery from that scooter brand new Lime gen 4.0 from 2021 ?
The big grey removable battery

It's a Lime-S gen4 (LSMT 4.0)

What does mean BMS ?